Place your slide or negative into the appropriate media holder.

Press the EV/Delete button again to complete the setting.

The amount of compensation is shown at the bottom of the LCD screen.

Press UP or DOWN button to adjust the exposure compensation from +2EV to -2EV in 0.5increments.

Press the EV/Delete button to adjust exposure value.

However, there may be times when you wish to make a photo lighter or darker. The exposure value (“EV” or brightness) is set automatically. TIP: If you see a black image on the LCD screen and do not see the image you want to scan, please check that both switches are on the “Photo setting.” Please do not insert the film holder into the scanner when scanning a photo. The scanned digital image will automatically store on your SD card.

Press the OK button to scan the picture.

3.4” x 2.1” (Polaroid Fuji instant photo).

4” x 4” (Polaroid or Fuji instant photo).

Select the size of the photo you wish to scan by pressing the DOWN button.

You will see the image of the media under the scanner on the LCD screen.

Press the Power button to turn on the scanner.

Slide the Photo/Film Light Switch to “PHOTO.” (See illustration at right.).

Slide Photo/Film Focus Switch to “PHOTO.” (See illustration at right.).

Remove the bottom tray and place the scanner on top of the image you wish to scan.

This allows you to duplicate precious family photos without disturbing delicate and fragile photo albums. Thanks to the preset focus and built-in glare-free LED lights, it is now possible to make a digital copy of a paper photo from a table top, or directly from a photo album, without removing it from the album. NOTE: If you are not able to see the light from your LCD screen, slide the Photo /Film Light Switch to its proper position. (This means you are not linked to a computer.) The LED indicator will light up Green or Blue, depending on your media selection. Press the Power button, then the OK button to select NO on the pop up icon on the LCD screen.Connect the USB cable to a computer or plug it into an AC outlet with the supplied adapter.Photo = a paper photo, small document or magazine article, etc. Slide the Photo/Film focus switch and Photo/Film light switch to the appropriate media. This unit accepts only SD or SDHC card up to a maximum of 32GB. Insert an SD memory card into the SD Card Slot until the card locks in place.LED on = Film scanning is enabled (35mm slide or negative).Green LED on = Photo scanning is enabled (paper photo or document).

Connect the Micro USB terminal to the Micro USB connector of the scanner. Connect the Micro USB wire to the power adaptor.Plug the Micro USB of the supplied USB cable to the USB connector of the scanner, and plug the other USB end into the USB port of your computer/notebook.

Free photo shaper